MDH
mh rollercalibtime
Japanese_Newspaper_OEM_Engine
This is the time used by the roller to offset the start of the two soleniods drivers
(if used on the system). The time can either be positive or negative depending on
if the "away" actuator should lead or lag the "home" actuator. This time will have
to be setup iteratively, since there is possible mechanical binding. The better the
value gets the less binding that will occur and the 'faster' things will happen.
Once there is less binding things may happen to fast, thus the value will have to
be tweaked again.
This parameter is available.
0.000 [seconds]
Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.
24-Apr-2003
Normal
..\..\ShowAllErrors.htmFirmware 1 Error Index
..\..\ShowAllCommands.htmFirmware 1 Command Index
..\..\ShowAllParameters.htmFirmware 1 Parameter Index